Anchoring in solid material

BackPrint this pageForward

Click on the arrow to start the Flashanimation.


How does it work?

Top
1.
Drill a borehole with a percussion drill.
2.
Clean borehole by blowing and brushing 4 times each.
3.
Screw mixer to the cartridge.
4.
Squeeze out and remove compound until a homogeneous grey color appears, then apply (approx. 10 cm).
5.
Starting from the bottom, fill ¾ of the borehole with mortar.
6.
Using a turning motion insert the reinforcement bar or threaded rod.
7.
Visual check of mortar filling and remove excess mortar.
8.
Observe correct hardening time. Please note, that curing time strongly depends on environmental temperature. You will find the correct curing time for each product in the Technical Data Sheets.
9.
Install fixing element and apply with torque.

Top

Back TopForward
 
© 2008 Henkel AG & Co. KGaA | Terms of use | Imprint | Privacy Policy | Note for US Residents